Commissioning — setting up a new system

Connect all devices to the panel and check their power supply according to the wiring diagram in the data sheet of the system.

Check the profile. It must match the equipment of the machine — The profile. If it does not, set it up first.

Check the connections. Every sensor must answer and be under control — see Indicators for the red cross and the not-controlled sign.

Set the general parameters in “Settings” → “Seeding machine parameters” (Settings menu): the working width, “Width, cm”; “Mode of seeding” — “Flow” for a grain drill; “Mode of fertilizers” — “Flow”.

Set the sensors (Sensor settings):

• speed sensor: “Diameter, cm” and “Pulses”; “Imitation, km/h” at “No”; then the speed calibration;
• dispenser shaft sensors: “Period, s”; if wanted, “Rotation speed control” or “Weight control”, each followed by its calibration;
• fans: “Pulses”, “Minimum, rpm”, “Maximum, rpm”;
• pressure sensors: “Filter”, “Minimum, Pa”, “Maximum, Pa”;
• implement position sensor: “Transporting position signal”;
• engine sensors: “Activation signal”;
• seed sensors, and separately fertilizer sensors: at least “Fraction” for the crop.

Set up the tramline, if the machine makes tramlines — after the profile, never before: Set up the tramline rhythm.

On machines with dispenser motors: assign the products and calibrate every motor — Assign a product to a motor, Calibrate a motor by weight.