Configure a pressure sensor
Give a new or replaced air pressure sensor its address.
Prepare first as in Device configuration: only this sensor on the cable, “Agronomist” level. The menu has the same three items as every configuration menu. The address values are not printed in this manual: take them from the data sheet of the system.
Choose “Service” → “Sensors Configuration” → “Pressure sensor” and press “MENU”. The menu shows “Sensor address”, “New address” and “Set”.
Leave “Sensor address” at “AUTO”.
Select “New address”. The panel proposes the correct value for the first pressure sensor by itself; each further sensor takes the next one. Check the value against the data sheet and correct it with “PLUS” / “MINUS” if needed.
Select “Set” and press “MENU”. The panel answers “Done”.
Disconnect the sensor and connect it again. On the home screen, check that its indicator appears.
When all sensors are done, set the level back to “Operator”, or switch the panel off and on. Its parameters: Pressure sensor.
Something your machine does that this page does not answer? Write to support@agriwelt.com — an engineer answers.