AGRIWELTDocs Hectare One
Setting up

Configure a HUB8

How toHectare One firmware · 1.2.3

Tell a HUB8 input device which sensor is wired to each of its eight channels.

The HUB8 carries several sensors at once. Its menu is longer than the others: after the device address come its eight channels, each with a type and a number. Prepare first as in Device configuration: only this HUB8 on the cable, “Agronomist” level.

The HUB8 menu with its first channels.
  1. “Device address” — which HUB8 the menu talks to. Leave it at “AUTO”.
  2. “Channel 1 type” — what kind of sensor is wired to channel 1.
  3. “Channel 1 address” — which sensor of that kind it is: hopper 1, dispenser 2, and so on.
  4. The value of the selected item, changed with “PLUS” / “MINUS”.
  5. Scroll bar. Channels 2 to 8 follow in the same pairs, then “Set”.
The HUB8 menu with its first channels.

The type and the number together make the sensor appear on the home screen under the right icon.

  1. Choose “Service” → “Sensors Configuration” → “HUB8” and press “MENU”.

  2. Leave “Device address” at “AUTO”.

  3. For each channel that carries a sensor, set “Channel N type” and “Channel N address” with “PLUS” / “MINUS”. Leave a channel that carries nothing as it is.

  4. Select “Set” at the end of the menu and press “MENU”. The panel answers “Done”.

  5. Disconnect the HUB8 and connect it again. On the home screen, check that each sensor appears under its icon.

When all devices are done, set the level back to “Operator”, or switch the panel off and on.

Something your machine does that this page does not answer? Write to support@agriwelt.com — an engineer answers.