Start here
About the pictures in this manual
The screens in this manual were shot on a test bench. What on them belongs to the bench and not to your machine.
The screens in this manual are real frames from a Hectare One panel, firmware 1.2.3, shot on a test bench instead of a machine in the field. A few things on them belong to the bench. Your panel shows the same screens without them.
| What you see in a picture | Why it is there | What your panel shows instead |
|---|---|---|
| A blue 0:00 in the top right corner, or the word TRIAL | The bench panel runs on a trial licence. While a trial is active, the clock slot cycles between the time left, the word TRIAL and blank. | The time of day. See Clock. |
| IMITAT in yellow in the clock slot | The bench runs in an imitation mode. | The time of day. |
| A yellow speed figure, or IMITATION in the speed field | The speed is simulated, not measured — there is no wheel turning on a bench. | The measured speed in white. See Speed. |
| Columns that move although the machine stands still | The seed flow is imitated by the sensors on the bench. | Columns that move only while seeding. |
| Red hoppers, a red oil can or battery | The bench has no product and no engine. | Green icons while everything is in order. |
| A red A box at the lower right of the home screen | Actuators named in the bench profile are not physically fitted, so the panel reports them as faulty. | Nothing — the box is not shown while every actuator is in order. See Actuator failure. |
| A red × in place of an icon | A device named in the bench profile is not connected. | The icon of the device. |
| Zeros on the Statistics screen | The bench statistics were empty when the frame was taken. | Your figures. |
Animated pictures are series of frames taken from the panel about seven seconds apart. They show how the screen changes while seeding, not how fast.
Something your machine does that this page does not answer? Write to support@agriwelt.com — an engineer answers.