Change the target rate
Raise or lower the rate the panel holds and guards, from the home screen, while seeding — by touch.
The rate field at the right end of each diagram shows two numbers: the measured rate on top, the target below it. In the “Flow” mode the target is the alarm level of the diagram — see The section diagram.
On a diagram
On the home screen, touch and hold the diagram whose rate you want to change, for more than half a second. Its target figure lights up.
The seed diagram with its target figure lit for editing. Swipe up over the screen to raise the target, down to lower it — one step per swipe. The target stays within its permitted limits.
Tap the screen outside the diagrams to finish. The figure stops being lit and the new target is in force.
To change another diagram — fertilizer after seed, say — touch and hold that diagram instead.
For a product applied by weight
Touch and hold the kg/ha indicator of the product. The number pad opens with the caption Product and the number of the product.
Type the target, from 10.0 to 500.0 kg/ha, and touch “OK” (Entering numbers). A tap outside the pad leaves the target as it was.
On the second home screen
Touch and hold the rate until it lights up, then swipe up or down. A tap elsewhere ends it. See Second home screen.
Something your machine does that this page does not answer? Write to support@agriwelt.com — an engineer answers.