Setting up
The Service menu
Every item of the "Service" menu, its access level, and which ones an engineer should leave alone.
Tap the home screen with two fingers, then tap “Service” twice. The menu itself is shown from the “Agronomist” level up; which items you see depends on the level (Access levels).
| Item | Level | What it is |
|---|---|---|
| “Profile” | Agronomist | Which devices the machine has, and how many. The profile |
| “Sensors Configuration” | Agronomist | Giving devices their address. Device configuration |
| “Registers” | Agronomist | A raw register view. Not part of any procedure. |
| “Electric motors” | Agronomist | The diagnostic screen and the configuration of the metering motor controllers. Configure the motor controllers |
| “Serial number” | Service | The serial number of the panel, entered once at manufacture. |
| “Imitation mode” | Service | “No” / “Yes” — the panel works from simulated data. See the warning below. |
| “Count seeds always” | Agronomist | “No” / “Yes” — “Yes” shows the seed counters in the “Flow” and “Hybrid” modes too; otherwise they are shown in the “Precise” mode only. |
| “Enter key” | Agronomist | Enters the licence key that takes the panel out of the demonstration state. Shown only while the panel is in that state. |
| “Set trial” | Service | Starts the demonstration period. |
| “Trial, hours” | Service | 1 … 999 — how long that period lasts. |
Four further items — the tracker protocol, two switches for logging to the memory card and the display type — exist in the firmware but are set never to be shown. They cannot be reached at any level.
“Imitation mode” is shown in English whatever language the panel is set to.
Something your machine does that this page does not answer? Write to support@agriwelt.com — an engineer answers.